Units for repair and well drilling
Hoist unit UPA-60A 60/80M
Hoist unit UPA-60A 60/80M is intended for development and repair of oil and gas wells and carrying out the following:
- lifting operations with pump and compressor, drill and casing pipes and pumping rods;
- clearing of sand plugs; well killing, circulation of washing solution during drilling, milling and other operations;
- drilling of cement sleeves, milling, etc.;
- ishing and other operations in the event of accidents at wells.
Mobile drilling rig ARS-250
Mobile drilling rig ARS-250 is designed to perform all types of work and technological operations when drilling oil and gas wells up to 4200 m deep in macroclimatic areas with a moderate climate (at temperatures from -45°C to + 40° C) when developing deposits with a hydrogen sulfide content of less than 6%.
Drilling rig (capacity 345 tons) Echelon type
Drilling rig with lifting capacity - with a permissible load on the hook of 320 metric tons with a block-modular system and a two-stage arrangement of blocks for cluster drilling, with frequency-controlled electric drives of the main mechanisms. The rig is designed for cluster drilling of production wells for oil and gas with a conditional drilling depth of up to 6000 meters.
Land rig (capacity 345 tons)
Land drilling rig (capacity 345 tons) is designed for drilling works during development and construction of oil wells. It includes a mast placed on the substructure, which also houses drawworks with a capacity of 1500 hp, a driller's control panel and other auxiliary equipment for tripping work and the drilling process.
Mobile drilling rig ARS-225
ARS-225 mobile drilling rig is designed to perform all types of work and technological operations during drilling and workover with a nominal hook load of not less than 225 metric tons.
Hoist unit ARS-200
The unit is designed to perform technological operations during drilling with a rotary table and downhole engines, well development, repair work, tripping of oilwell tubing and drilling pipes, installation of operational equipment on the wellhead and breakdown elimination.
Hoist unit ARS-125
The unit is designed to perform technological operations during drilling, well develolpment, repair work, tripping of oilwell tubing and drilling pipes, installation of operational equipment on the wellhead and breakdown elimination. The off-road self-propelled unit is mounted on the MZKT chassis with a wheel arrangement of 12x10, a load capacity of 431.2 kN (44.0 tf), equipped with diesel engine Caterpillar-C15 ACERT with an installed capacity of at least 397 kW (540 hp) with an Allison transmission.
Hoist unit ARS-100
The off-road self-propelled unit is mounted on a chassis MZKT-7004 with a 10x8 wheel arrangement with a load capacity of 392.2 kN (40.0 TS), equipped with a preheating system a running diesel, 6-cylinder, inline engine Caterpillar C-15 Electronic.
Hoist unit AP-80 A
Hoist unit AP-80 A is designed for the development and repair of oil and gas wells. The scope of application of the unit is performing technological operations during well development, repair work, running and pulling-out of tubing, installation of service equipment at the wellhead and breakdown elimination.
Hoist unit AP-80
Hoist units AP-80 are designed for development and repair of oil and gas wells.
The scope of application of the units is the performance of technological operations during the development of wells, repair work, running and pulling-out of tubing, installation of service equipment at the wellhead and breakdown elimination.